2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 21

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
Grease the linear bearings before using them. Don't forget to add the
X-carriage onto the smooth rods.
Secure the smooth rods with the rod clamps on each x end part. Make sure the rods are
centred.
Check that the construction can smoothly go up and down on the vertical rods without any
blocking. If necessary vary the tension of the screws on the linear bearings until the
construction slides easily.
Let the z-axis slide down until it sits on the y carriage.
Also check if the X-carriage can slide smoothly on the horizontal rods and secure the screws
on the linear bearings.
NOTICE
12/10/12
Page 21/ 53