Table of Contents
Advertisement
Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
12/10/12
Push the hotend onto the hotend clamp. Make sure it is pushed in fully, if needed use pliers.
Place the hotend with it's clamp onto the x-carriage and the pre-assembled extruder on top of
it. Make sure cables from the hotend are on the extruder side without gears.
Use two M4x20 mm screws and fitting washers to secure the extruder to the x-carriage.
It is also possible to mount the extruder turned 180°.
Page 30/ 53
Advertisement
Table of Contents
