Step 2.1 - 2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild

Step 2.1

Needed parts for step 2.1
The following parts are needed for this step:
1x Gear
1x pre-assembled y-carriage
1x Motor Nema17 with cable and plug
3x Washer M3
3x Screw M3 x 10 mm
2x Smooth rod 8mm x 406 mm
and the structure from the previous step
Push the smooth rods through the bar clamps on the frame and slide on the linear bearings.
Do not fasten the nuts on the rod clamps yet. Make sure that the pre-mounted endstopflag is
positioned on the side of the y motor.
Grease the linear bearings before using them.
Make sure that the pre-mounted endstopflag is positioned on the side
of the y motor.
NOTICE
12/10/12
Page 14/ 53