2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 10

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Insert the two triangles from the outside into the prepared threaded rods and fix them
together with a washer and a nut each. The longer threaded rods (440 mm) go into the frame
vertices without feet, the shorter ones (294 mm) in the Frame vertexes without feet like it's
shown in the picture.
Distance between the frame triangles.
Measure the distances between the triangles, as shown above, on all three sides of the
frame.
Position of the nuts on the outside of the frame.
Now adjust the distance between the triangles by turning the nuts on the frame vertices until
all distances are exactly the same. Make sure the triangles are as far out as possible, as
shown above. The distance between the bolts should be around 260 mm.
Page 10/ 53