Table of Contents
Advertisement
Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
Attention, the pins of the thermistor are very fragile and might break
easily!
The push the thermistor into the small hole of the J-Head like it is shown in the picture above.
Fixate the thermistor at the nozzle with a small piece of heat resistant tape or glue. You
should make sure, it cannot drop out the nozzle.
Secure the thermistor cable and the cable of the heating element on the J-head with a piece
of tape.
NOTICE
12/10/12
Page 28/ 53
Advertisement
Table of Contents
