Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
12/10/12
Step 4.2
Needed parts for step 4.2
The following parts are needed for this step:
2x Bearing holders
2x Bearing 608ZZ
2x Screw M3 x 25 mm
2x Nut M3
4x Washer M3
and the structures from the previous steps
Assembly step 4.2
Press the bearings into the bearing holders and place them onto the lower end of both Z
drive rods. Secure the holders with a M3 x 25 mm screw and a washer each.
Page 33/ 53