2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 51

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Connection of the end-stops to the electronic
Connect the cable to the electronic as shown in the picture above. Again make sure to use
the correct pins for the plug and that the marked side of the cable points to the USB plug.
Connection of the heated print bed
If you have the deluxe set, guide the cables of the heated print bed to the electronics as it is
shown in the picture above.
Make sure that the y-axis can still move over its full range without any problems and that the
cables don't entangle with the belt.
Connection of the heated print bed to the electronics
Page 51/ 53