Table of Contents
Advertisement
Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
12/10/12
Now pull the belt over the belt clamp, around it and under the clamp to the outside.
Like it is shown in the pictures above. Pull the belt tight and fasten the screws on the belt
clamp. You can now adjust the belt tension with the horizontal screw.
Cut off the surplus belt very near the belt clamp, it will be needed for the X axis.
Check again that the y carriage can run smoothly on the smooth rods over its full range.
Page 17/ 53
Advertisement
Table of Contents
