Step 3.1 - 2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12

Step 3.1

Needed parts for step 3.1
The following parts are needed for this step:
1x Heating element
1x Thermistor with cable
1x J-Head
Assembly step 3.1
Before installing the hotend you should make sure that the nozzle is screwed into the holder
to the very end. If there is a gap between the holder and the inner part of the nozzle the
hotend might block. Therefore put a toothpick into the hotend and check, if you can feel a
significant gap inside the hotend.
Push the heating element into the big hole of the J-Head and secure it with the integrated
grub screw.
Page 27/ 53