2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 41

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Click the filament guide onto the rods on the top of the 3D printer.
Attach the 40 mm fan with two M3 x 20 mm screws, washers and nuts to the metal strip.
Screw the fan director to the fan with two M3 x 10 mm screws. Then attach the strips to a
screw of the x carriage and bend them so that the fan blows at the black part of the hotend.
Assembly RAMPS
Attach the RAMPS electronic holder onto the side of the 3D printer with four rod clamps and
two M3 x 30 mm screw, washers and nuts each.
Put the RAMPS electronic onto the holder and secure it with three M3 x 25 mm screws,
washer on top and bottom, and a M3 nut.
Page 41/ 53