Step 4.3 - 2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12

Step 4.3

Needed parts for step 4.3
The following parts are needed for this step:
1x Mirror plate 200 mm x 200 mm
4x thick Spring (8mm)
1x Kapton tape
8x Washer M3
4x Nut M3 Nyloc
4x Screw M3 x 30 mm
1x pre-assembled Heated print bed
4x Foldback clamps
Assembly step 4.3
Mount the heated print bed onto the y carriage with four M3 x 30 mm screw, the spring,
which was cut into 4 parts, washers and nuts as shown in the picture above. The M3 Nyloc
Page 34/ 53