Table of Contents
Advertisement
Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
Please make sure to not cut the cables too short. Always put the cables into
the intended place to test the length before cutting it.
We start with the Z-axis motors. Move both cables to the side where the electronic is and run
the cables down the rod on this side to the electronics.
Connection of the z motors
Cable management for the z motor
The highlighted cable in this picture are the Z-motor cables. Plug both cables in like it is
shown the pictures below. Make sure the blue cable is on the right side.
NOTICE
12/10/12
Page 43/ 53
Advertisement
Table of Contents
