2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 48

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Connection of the NTCs to the electronic
The motor cable plugs into the last free motor connector on the electronics as shown above.
Make sure the blue cable is again on the right side.
The thermistor cable plugs into the pin row in the middle of the electronics as shown above.
Here the colour coding doesn't matter.
The cables of the heater need to be connected to the lowest screw terminals on the
electronics as shown above. Here the colour coding also doesn't matter.
The fan cables go onto the middle screw terminal.
Connection of the x end-stop
For the end-stops we take a three-wire cable with the plugs on both sides. Plug the cable into
the end-stop, with the marked side pointing to the front, and guide it in a small loop to the
side of the printer and then down to the electronic. Make sure the cable has enough space,
so the z-axis can move completely up and down.
On the electronics, plug the cable into the rightmost socket, as shown in the image above.
Make sure the marked side of the cable points to the USB plug of the electronics.
Page 48/ 53