2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 15

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Assembly y carriage
Push the gear onto the motor shaft and secure it with the integrated grub screw. Make sure
one grub screw is positioned over the flat side of the motor shaft.
Now attach the motor to the y motor holder with three M3 screws and washers as shown in
the picture below. Make sure the motor cables on the motor are pointing downwards.
Assembly of the Y Axis motor
Then adjust the smooth rods with the rod clamps until the Y carriage sits exactly in the
middle of the frame and can be moved without problems. The smooth rods should now be
exactly parallel and should have the same distance to the threaded rods on both sides of the
frame. Now carefully fasten the bar clamps until the smooth rods can't be moved any more.
Now fasten the screws on the linear bearings and check again that the y carriage runs
smoothly.
Page 15/ 53