2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 45

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Connection of the y motor onto the electronics
Plug the cable into the middle motor socket of the electronic, as shown with the highlighted
cable above. Again make sure that the blue cable is on the right side.
Connection of the x motor
To connect the x-axis motor, guide the motor cable in a loose curve onto the diagonal rod
and from there on downwards. Make sure the is enough cable that the Z-axis can move fully
up and down.
Guide the cable below the printbed along the middle rod to the electronics.
Page 45/ 53