2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 50

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Connection of the y end-stop
For the last end-stop we again use a three-wire cable and connect it to the end-stop. Make
sure the marked side points to the front of the end-stop. Guide the cable along the side of the
printer till you get to the middle rod. From there guide it below the printer, alongside the
middle rod, to the electronic.
Connection of the y end-stop to the electronic
Page 50/ 53