2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 49

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild 12/10/12
Connection of the x end-stop to the electronic
The end-stops are protected against reverse connection. So if the cable is plugging in the
wrong directions, you can easily correct it later.
Connection of the z end-stop
Connect another three-wire cable to the z end-stop and guide the cable down the vertical rod
and plug it into the electronic like the red cable shown in the picture above. Make sure to
plug it into the correct socket. There is always on free row of pins between the end-stop
plugs. Again make sure the marked side of the cable points to the front of the endstop and on
the electronic to the USB plug.
Page 49/ 53