Table of Contents
Advertisement
Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
12/10/12
Place the terminal block, onto the extruder motor and connect the fan cables to it as shown
in the picture above. Connect the thin two-wire cable for the fan to the terminal block. Make
sure to pay attention to the colour coding.
Cable management of the Extruder
Guide the motor cable, the heater cable, the fan cable and the already connected thermistor
cable in a big loop to the top of the printer and from there down on the side of the printer to
the electronic.
Make sure loop of the cables is big enough, so that the extruder can move in x and z
direction over its full range without getting in conflict with the cables.
Connection of the extruder to the electronic
Page 47/ 53
Advertisement
Table of Contents
