2Print Beta Beta Prusa V2 Deluxe EasyBuild Assembly Instructions Manual page 19

Assembly Instructions Beta Prusa V2 Deluxe - EasyBuild
Grease the linear bearings before using them. Don't forget to add X-
ends onto the smooth rods.
On the top the smooth rods are secured with rod clamps, M4 x 16 mm screws and
associated washers and nuts. You can see how that is done on the following pictures. The
M4 nuts are already casted in.
Assembly detail step 2.3
Justage step 2.3
Now adjust the two bar clamps, like its shown in the picture above, until the new smooth rods
are exactly vertical. Use a plum line, which you can easily create yourself with a M8 nut and
a thread, to make sure its really vertical. When you are satisfied with this, carefully fasten the
bar clamps until the rods can't be moved any more.
NOTICE
12/10/12
Page 19/ 53