Table of Contents
Advertisement
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , WAAS SETTING , NG WAAS , and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, select NO USE or USE by turning [JOG
DIAL] and end the operation by pressing [JOG DIAL] or [ACQ/ENT].
4. Setting a satellite number [MENU]
This function sends the setting of a WAAS satellite that is used to a WAAS receiver.
A number between 120 and 138 can be selected automatically.
Use the following procedure to set a number of the WAAS satellite that is used.
Use the following procedure to set a number of the WAAS satellite that is used.
Use the following procedure to set a number of the WAAS satellite that is used.
Use the following procedure to set a number of the WAAS satellite that is used.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , WAAS SETTING , WAAS NO. , and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, select either a number between 120 and 138
or AUTO by turning [JOG DIAL] and end the operation by pressing [JOG DIAL] or
[ACQ/ENT].
5. Sending updated setting values [MENU]
This function sends the information of items 1 to 4 that was set to WAAS to a WAAS receiver.
The values that are set in items 1 to 4 are not set in the WAAS receiver without this
transmission operation even if the values are changed and set on the menu.
Use the following procedure to send updated setting values to a WAAS receiver.
Use the following procedure to send updated setting values to a WAAS receiver.
Use the following procedure to send updated setting values to a WAAS receiver.
Use the following procedure to send updated setting values to a WAAS receiver.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , WAAS SETTING , TX COMMAND and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed and transmission starts, message "TRANSMIT..." is
displayed. If the transmission completes successfully, "COMPLETE!" is displayed. If
the transmission fails, "TX FAILED!" is displayed. In this case, start the procedure from
(a) again.
WAAS SETTING
MODE
AUTO
RANGING
ON
NG WAAS
NO USE
NO USE
AUTO
USE
WAAS SETTING
MODE
AUTO
RANGING
ON
NG WAAS
NO USE
WAAS NO.
AUTO
AUTO
WAAS SETTING
MODE
AUTO
RANGING
ON
TX COMMAND
NO USE
TRANSMIT...
AUTO
COMPLETE!
181
Advertisement
Table of Contents
