Table of Contents
Advertisement
9.7.4 0 mile adjustment [TM/RM] [AZI MODE] [MENU]
This operation is to adjust the distance calibration on the PPI screen.
Use the following procedure for 0 mile adjustment.
Use the following procedure for 0 mile adjustment.
Use the following procedure for 0 mile adjustment.
Use the following procedure for 0 mile adjustment.
(a) Select the RM mode by pressing the [TM/RM] key.
When the mode is already set to "RM", this operation is not necessary.
(b) Select the H-UP mode by pressing the [AZI MODE] key.
When the mode is already set to "H-UP", this operation is not necessary.
(c) Set the range to 0.125 miles by pressing the [+RANGE-] key.
(d) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
RADAR , RADAR ADJUST , and DISPLAY TIMING , and press [JOG DIAL] or
[ACQ/ENT].
(e) Set the target to the right distance position on the screen by turning [JOG DIAL] and end
the operation by pressing [JOG DIAL] or [ACQ/ENT].
9.7.5 Setting a scanner unit height [MENU]
Set a height from a surface of the sea to the scanner unit of the radar.
By changing this setting value, the effect of the STC function (sea clutter elimination function) for
distances can be changed.
This function is also useful for changing the effect of the [AUTO-SEA] knob.
Use the following procedure to set a scanner unit height.
Use the following procedure to set a scanner unit height.
Use the following procedure to set a scanner unit height.
Use the following procedure to set a scanner unit height.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
RADAR , RADAR ADJUST2 , and ANTTENA HEIGHT , and press [JOG DIAL] or
[ACQ/ENT].
Ｂ Ｂ Ｂ Ｂ Ｅ Ｅ Ｅ Ｅ Ａ Ａ Ａ Ａ Ｒ Ｒ Ｒ Ｒ Ｉ Ｉ Ｉ Ｉ Ｎ Ｎ Ｎ Ｎ Ｇ Ｇ Ｇ Ｇ
0 0 0 0 3 3 3 3 4 4 4 4 5 5 5 5
Ｄ Ｄ Ｄ Ｄ Ｉ Ｉ Ｉ Ｉ Ｓ Ｓ Ｓ Ｓ Ｐ Ｐ Ｐ Ｐ Ｌ Ｌ Ｌ Ｌ Ａ Ａ Ａ Ａ Ｙ Ｙ Ｙ Ｙ
Ｔ Ｔ Ｔ Ｔ Ｉ Ｉ Ｉ Ｉ Ｍ Ｍ Ｍ Ｍ Ｉ Ｉ Ｉ Ｉ Ｎ Ｎ Ｎ Ｎ Ｇ Ｇ Ｇ Ｇ
0 0 0 0 3 3 3 3 4 4 4 4 5 5 5 5
158
Advertisement
Table of Contents
