Table of Contents
Advertisement
9.8.24 Setting manual speed data [MENU]
Input a manual course required when manual is selected as the speed data input on the menu
shown above.
Use the following procedure to set speed data input.
Use the followi
Use the followi
Use the followi
ng procedure to set speed data input.
ng procedure to set speed data input.
ng procedure to set speed data input.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
DATA/IN OUT and MANUAL SPEED and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, select a course by turning [JOG DIAL] and end the
operation by pressing [JOG DIAL] or [ACQ/ENT].
9.8.25 Setting own ship's position input selection [MENU]
This function enables selection of position information from GPS or manual input as the method
for inputting an own ship's position. When GPS is selected, position information from GPS is
used and when manual is selected, the position information that is set by manual input shown in
the next item is used.
Use the following procedure to select own ship's position input selection.
Use the following procedure to select own sh
Use the following procedure to select own sh
Use the following procedure to select own sh
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
DATA/IN OUT and POSITION IN and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, select
operation by pressing [JOG DIAL] or [ACQ/ENT].
Note
The signals of NMEA0183 which can be received from J3 of GPS port are as follows.
GGA, GLL, VTG, RMB
DATA/IN OUT
COURSE IN
COMPASS GYRO
MANUAL COURSE 000°
SPEED IN
GPS BT
MANUAL SPEED
00.0 KT
00.0 KT
GPS
MANUAL POS.
N 36°36.000'
E136°36.000'
COMPASS PORT
JLR-10(9600)
2ND PANEL
DISABLE
NMEA OUT
>
CALIBRATION >
ip's position input selection.
ip's position input selection.
ip's position input selection.
DATA/IN OUT
COURSE IN
COMPASS GYRO
MANUAL COURSE 000°
SPEED IN
GPS BT
MANUAL SPEED
00.0 KT
POSITION IN
GPS
MANUAL
N 36°36.000'
GPS
E136°36.000'
COMPASS PORT
JLR-10(9600)
2ND PANEL
DISABLE
NMEA OUT
>
CALIBRATION >
185
MANUAL
or
GPS
and end the
Advertisement
Table of Contents
