Table of Contents
Advertisement
9.8.26 Setting own ship's position input [MENU]
Set manual input of own ship's position that is required when manual is selected in the own ship's
position input from the menu shown above.
Use the following procedure to set speed data input.
Use the following procedure to set speed data input.
Use the following procedure to set speed data input.
Use the following procedure to set speed data input.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
DATA/IN OUT and MANUAL POS. and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, set the values of South and North of the latitude,
the unit of degree, the unit of minute, and the unit of second in that sequence by changing
the values using the [JOG DIAL] and determine each value by pressing [JOG DIAL] or
[ACQ/ENT]. When the information up to the second of latitude has been confirmed, the
cursor moves to the longitude line. Change the values of East and West of the longitude,
the unit of degree, the unit of second in that sequence by turning [JOG DIAL] and
determine each value by pressing [JOG DIAL] or [ACQ/ENT].
9.8.27 Setting a compass input baud rate [MENU]
Set a baud rate of a compass port.
Optional NSK unit : 9600BPS
GPS compass JLR-10 of JRC : 9600BPS
NEMA-0183 input equipment such as electronic compass : 4800BPS
Use the following procedure to set speed data input.
Use the following procedure to set speed data input.
Use the following procedure to set speed data input.
Use the following procedure to set speed data input.
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
DATA/IN OUT and COMPASS PORT and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed, select NSK (9600) , JLR-10 (9600) , or
COMPASS (4800) and end the operation by pressing [JOG DIAL] or [ACQ/ENT].
DATA/IN OUT
COURSE IN
COMPASS GYRO
MANUAL COURSE 000°
SPEED IN
GPS BT
MANUAL SPEED
00.0 KT
POSITION IN
GPS
MANUAL POS.
N 36°36.000'
N 36°36.000' E136°36.000'
E136°36.000' JLR-10(9600)
2ND PANEL
DISABLE
NMEA OUT
>
CALIBRATION >
186
Advertisement
Table of Contents
