JRC JMA-5104 Instruction Manual page 204

Use the following procedure to set updated setting values Use the following procedure to set
Use the following procedure to set Use the following procedure to set
(a) Display the INSTALLATION menu by pressing the [MENU] key in long mode, select
GPS , GPS SETTING2 , TX COMMAND and press [JOG DIAL] or [ACQ/ENT].
(b) When the following menu is displayed and transmission starts, message "TRANSMIT..." is
displayed. If the transmission completes successfully, "COMPLETE!" is displayed. If
the transmission fails, "TX FAILED" is displayed. In this case, starts the procedure from
(a) again.
updated setting values. . . .
updated setting values updated setting values
GPS SETTING2
UTC 2003/01/23
TX COMMAND 23:59:59
TRANSMIT... +00:00
COMPLETE!
177