Operation Procedures; Calling A Function; Changing The Setting Of A Function Key; Changing A Function Key Title - JRC JMA-5104 Instruction Manual

3.6.2 Operation procedures

1. Calling a function

Each time the [FUNC] key is pressed, the cursor moves in the following sequence: Each time the Each time the Each time the
STANDARD → → → → FUNC1 STANDARD FUNC1 → → → → FUN
STANDARD STANDARD FUNC1 FUNC1
The title of the currently called mode is displayed at the upper right of the screen.
Suppose that signal processing settings are defined for FUNC1 with COAST as the title,
FUNC2 with DEEPSEA as the title, FUNC3 with FISHNET as the title, and FUNC4 with
RAIN as the title. Each time the [FUNC] key is pressed, the function titles are displayed at
the upper right of the screen in the order of COAST, DEEPSEA, FISHNET, and then RAIN.
You can confirm the currently selected function mode glancing at the screen.

2. Changing the setting of a function key

You can change the settings of a function key just as when performing general operation.
After the title displayed at the upper right of the screen is switched by pressing the [FUNC] key,
settings made in that status are stored as they are.
For example, if FUNC1 (COAST) is selected by pressing the [FUNC] key, the title COAST is
displayed at the upper right of the screen. This explains that the coast navigation function
mode is now active. Settings (e.g., signal processing settings and radar setting) made in the
mode are stored for FUNC1 (coast navigation mode).

3. Changing a function key title

The title displayed at the upper right of the screen can be easily changed.
Perform the procedure below to change any of the factory-set titles previously mentioned.
Take the following steps to change a function key title: Take the following steps to change a function key title: Take the following steps to change a function key title: Take the following steps to change a function key title:
(a) Hold down the [FUNC] key to display the FUNCTION menu.
(b) The menu below is displayed. Select the function key FUNC1 to FUNC4 of which
title you want to change, and then press the [JOG DIAL] or [ACQ/ENT] key.
(c) The menu below is displayed.
[ACQ/ENT] key.
key is pressed, the cursor moves in the following sequence: key is pressed, the cursor moves in the following sequence: key is pressed, the cursor moves in the following sequence:
FUNC2 C2 → → → → FUNC3 FUNC3 → → → → FUNC4
FUN FUN C2 C2 FUNC3 FUNC3
FUNCTION
STANDARD
FUNC1
FUNC2
FUNC3
FUNC4
Select
STANDARD
MODE
VIDEO
TRAILS
PULSE LENGTH >
INITIALIZE
FUNC4 → → → → STANDARD STANDARD
FUNC4 FUNC4 STANDARD STANDARD
>
>
>
>
>
MODE , and then press the [JOG DIAL] or
> COAST
>
>
>
76