Setting A Trail Interval [Trails]; Clearing Stored Trail Data [Trails]; Setting A Trail Reference Level (Trail Threshold) [Trails] - JRC JMA-5104 Instruction Manual

Marine radar equipment
Hide thumbs Also See for JMA-5104:
Table of Contents

Advertisement

2. Setting a trail interval [TRAILS]

(a) Hold down the [TRAILS] key to display the TRAILS menu.
(b) Operate [JOG DIAL] to select TRAIL INTERVAL , and then press the [JOG DIAL] or
[ACQ/ENT] key.
(c) The menu below is displayed. Turn [JOG DIAL] to set a value 30 to 59 seconds or 1 to 99
minutes, and then press the [JOG DIAL] or [ACQ/ENT] key to determine the setting.
TRAIL INTERVAL
TRAIL REF LVL 8
TRAIL SUPRESS 0.0NM
TRAIL CLEAR
RANGE TRAIL
Caution
● ● ● ● Because wake time may err by the rotation speed of scanner unit or the setting
timing, surely use this as a standard.

3. Clearing stored trail data [TRAILS]

(a) Hold down the [TRAILS] key to display the TRAILS menu.
(b) Operate [JOG DIAL] to select
[ACQ/ENT] key.
(c) Select ON , and then press the [JOG DIAL] or [ACQ/ENT] key to determine the selection.
TRAIL INTERVAL 6M
TRAIL REF LVL 8
TRAIL SUPRESS 0.0NM
TRAIL CLEAR
RANGE TRAIL
(d) The ON selected above is automatically changed back to OFF when the stored trail
data has been cleared.

4. Setting a trail reference level (trail threshold) [TRAILS]

A trail reference level is used to determine whether to store trail data depending on the
strength of targets.
A level 0 to 15 can be set as a threshold.
When level 1 is set, the data of all the targets displayed on the PPI screen is stored/displayed.
As a higher level is set, the trail data of only stronger targets is stored/displayed.
Level 8 is usually set.
If sea clutters are strong and they are also stored/displayed, set a level higher than 8.
Conversely, if the trail data of weak targets is difficult to store/display, set a level lower than 8.
Take the following steps to set a trail reference level (trail threshold):
Take the following steps to set a trail reference level (trail threshold):
Take the following steps to set a trail reference level (trail threshold):
Take the following steps to set a trail reference level (trail threshold):
TRAILS
6M
OFF
CLEAR
TRAIL CLEAR , and then press the [JOG DIAL] or
TRAILS
OFF
CLEAR
TRAILS
TRAIL INTERVAL
6NM
TRAIL SUPRESS 0.0NM
TRAIL CLEAR
RANGE TRAIL
TRAILS
TRAIL INTERVAL 6M
TRAIL REF LVL 8
TRAIL CLEAR
OFF
ON
57
6M
8
OFF
CLEAR
0.0NM
OFF
CLEAR

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jma-5106Jma-5110Nke2042

Table of Contents