3.7 Other Procedures Required
3.7.1 Confirming software versions [MENU]
The versions of software installed in the processor, antenna, and operation unit can be displayed.
If a failure occurs, inform our engineer of the software versions as well as details on the failure.
Take the following steps to confirm the software versions:
Take the following steps to confirm the software versions:
Take the following steps to confirm the software versions:
Take the following steps to confirm the software versions:
(a) Press the [MENU] key to display MENU .
(b) Select INFORMATION and then SOFTWARE VER. pressing the [JOG DIAL] or
[ACQ/ENT] key after each selection.
The software versions are displayed as shown below.
3.7.2 Confirming the operating status of connected units [MENU]
The status of the units (e.g., the processor, antenna, and operation unit) currently connected to
this radar can be displayed.
If a failure occurs, inform our engineer of the unit connection status as well as details on the
failure.
Take the following steps to confirm the unit connection status:
Take the following steps to confirm the unit connection status:
Take the following steps to confirm the unit connection status:
Take the following steps to confirm the unit connection status:
(a) Press the [MENU] key to display MENU .
(b) Select
INFORMATION
[ACQ/ENT] key after each selection.
The unit connection status is displayed as shown below.
SOFTWARE VER.
MAIN
V 1.00
2003/01/01
PANEL
V 1.00
PANEL2
V 1.00
SCANNER
V 1.00
ATA
V 1.00
NSK
------
and then PORT CONNECT pressing the [JOG DIAL] or
PORT CONNECT
GPS
NMEA0183
COMPASS
JLR-10
PC
NMEA0183
SCANNER
CONNECT
PANEL
CONNECT
PANEL2
NONE
ATA
NONE
79