Requirements On The Throttle Lever - Rotax 912 Series Installation Manual

Cable actuation
Graphic
Fig. 10
2.4)

Requirements on the throttle lever

See
Mechanical stops
Adjustable positive stops for idle- and full throttle position are of course
required.
These stops have to be designed such to render adjustibility and to pre-
vent overload of the idle stop on the carburetor.
Effectivity: 912 Series
Edition 2/Rev. 0
BRP-Powertrain
INSTALLATION MANUAL
2
1
Part
1 Lever flap
2 Return spring
3 Cable sleeves
4 Adjustment screws
Adjust Bowden cable such that throttle and choke can
WARNUNG WARNING
be fully opened and closed.
Use Bowden cable with minimized friction so that the
spring on the throttle can open the throttle completely.
Otherwise increase pretension of spring by bending
lever flap (1) or fit a stronger return spring, (2) or a
cable with pull-push action would have to be used.
Secure the bowden cable sleeves (3) in the adjustment
screws (4) (e.g. safety wire).
Fig. 11.
4
3
Function
08338,08354
73-00-00
page 18
August 01/2012