Preparations For Engine Installation; State Of Delivery; Unpacking/Handling Of The Engine - Rotax 912 Series Installation Manual

1) Preparations for engine installation

1.1)

State of delivery

Attachment
The engine can be attached with steel angles anchored on a timber plate.
- When the engine is delivered, check that the GENUINE-ROTAX pack-
- If the packing is damaged, contact the authorised sales and service
1.2)

Unpacking/handling of the engine

To unpack a new engine, proceed as follows:
Unpacking the
engine
To check the state of delivery, proceed as follows:
After unpacking
The engine to be lifted by two hooks or straps around the middle (A) of
Suspension point
the intake manifolds.
See chapter engine views, numbering of cylinders and definitions of main
axes.
Effectivity: 912 Series
Edition 2/Rev. 0
BRP-Powertrain
INSTALLATION MANUAL
Risk of consequential damage to engine and aircraft
NOTICE
WARNUNG
as a result of corrosion and damage.
Under no circumstances is a corroded or damaged
engine to be installed in an aircraft!
The attachment screws are only for transport and
NOTICE
WARNUNG
must not be used in the aircraft.
ing is not damaged.
partner for ROTAX aircraft engines.
Step
1 Remove the wooden cover.
2 Remove the protective packaging.
3 Remove the protective film around the engine.
Step
1 Check that the serial number and engine type designation on the
type plate are identical to those shown on the delivery note.
2 Check the engine for damage or corrosion. If everything is
deemed "OK", the engine can be accepted.
Procedure
Procedure
10-10-00
page 3
August 01/2012