Adjustment Of The Front Derailleur; Using Two Shifting Switches For Adjustment - Shimano XTR Di2 Dealer's Manual

ADJUSTMENT

Adjustment of the front derailleur

„ Adjustment of the front derailleur
Adjust the front derailleur using the following procedure.
• Top side position adjustment
Use the adjustment screw of the front derailleur for adjustment.
• Middle position adjustment (for front triple), low position adjustment
Switch the information display to adjustment mode and use the shifting switch for adjustment.
The shifting switch configuration is divided into two types: right and left shifting switches or a one-side shifting switch. The adjustment of the front
derailleur differs depending on the type used. Refer to "When using two shifting switches for adjustment" or "When using one shifting switch for
adjustment" depending on the number of shifting switches your bicycle has.
When using two shifting switches for adjustment
< Top side position adjustment >
(B)
1
2
To be continued on next page
(A) Set the chain onto the largest chainring
(A) and the largest sprocket (B).
If the rear derailleur cannot be set to the
largest sprocket in synchronized mode,
(A)
switch to manual mode before setting
the rear derailleur to the largest
sprocket.
(B)
Loosen the stroke fixing bolt (C) with a
2 mm Allen key.
(C)
56
(A)
Largest chainring
(B)
Largest sprocket
(C)
Stroke fixing bolt