To Ensure Safety - Shimano XTR Di2 Dealer's Manual

TO ENSURE SAFETY

TO ENSURE SAFETY
Be sure to also inform users of the following:
„Lithium ion battery
Be sure to observe the following in order to avoid burns or other injury from fluid leakages, overheating, fire or explosions.
• Use the designated charger to charge the battery. If any non-specified items are used, fire, overheating or leakages may occur.
• Do not heat the battery or throw it into fire. If this is not observed, fire or bursting may occur.
• Do not disassemble or modify the battery or apply solder directly to the battery terminals. Do not leave the battery in places which may exceed 60°C in
temperature, such as places which are exposed to direct sunlight inside vehicles on hot days or near stoves. If this is not observed, leakages,
overheating or bursting may cause fire, burns or other injury to occur.
• Do not connect the (+) and (-) terminals with metallic objects. Do not carry or store the battery together with metallic objects such as necklaces or
hairpins. If this is not observed, short-circuits, overheating, burns or other injury may occur.
• If any liquid leaking from the battery gets into the eyes, immediately wash the affected area with clean water without rubbing the eyes, and then
seek medical attention. If this is not done, blindness may occur.
„Battery charger / Battery charger cord
Be sure to observe the following in order to avoid burns or other injury from fluid leakages, overheating, fire or explosions.
• Do not get the charger wet or use it while it is wet, and do not touch or hold it with wet hands. If this is not observed, problems with operation or
electric shocks may occur.
• Do not cover the charger with a cloth or similar while it is in use. If this is not observed, heat may build up and the case may become deformed, or fire
or overheating may occur.
• Do not disassemble or modify the charger. If this is not observed, electric shocks or injury may occur.
• Use the charger at the specified power supply voltage only. If a power supply voltage other than that specified is used, fire, explosions, smoke,
overheating, electric shocks or burns may occur.
• Do not touch metallic parts of the charger or the AC adapter if there is a lighting storm. When lightning strikes, an electric shock may be caused.
SM-BCR2: Battery charger for SM-BTR2
• Use an AC adapter with a USB port with a voltage of 5.0 VDC and with a current equal to or higher than 1.0 ADC. If the one with a current lower than
1.0 A is used, the AC adapter may heat up, potentially causing a fire, smoke, overheating, destruction, electric shock, or burns.
DANGER
5