Connection And Communication With The Pc; Settings Customizable In E-Tube Project - Shimano XTR Di2 Dealer's Manual

Connection and communication with the PC

Settings customizable in E-tube Project

Connection and communication with the PC
You can connect the bicycle (system or components) to a PC via a PC linkage device to carry out tasks such as customizing single components or the whole
system and updating their firmware.
E-tube project is needed to configure the system and update firmware. Download E-tube Project
from our support website (http://e-tubeproject.shimano.com).
For information on how to install E-tube Project, check the support website. For information on how
to use E-tube Project on your PC, refer to the help manual for E-tube Project.
< System requirements >
• PC linkage device : SM-PCE1/SM-BCR2
• E-tube Project : version 2.6 or later
• SM-BTR1, SM-BTR2, SM-BTE2 firmware
„ Settings customizable in E-tube Project
Beep setting
Display monitor
settings
Display time
Switch setting
Front derailleur adjustment setting
Rear derailleur adjustment setting
Synchronized shift map setting
Suspension type setting
Multi-shift mode ON/OFF
Multi shift
Gear-shifting interval
mode setting
Gear number limit
: version 3.0.0 or later
You can switch the beep between ON and OFF.
Sets the time until the display turns off when the display monitor is left unattended.
Changes the function settings of the shifting switch and suspension switch.
Adjust the front derailleur.
Adjust the rear derailleur.
Modify the synchronized shift map settings.
Set the suspension type.
Select whether or not to use multi-shift.
Sets the gear-shifting interval for multi-shift.
Sets the limit on the number of gears shifted when the shifting switch is held down.
77
•
SM-PCE1 and SM-JC40/JC41 are needed to
connect the system to a PC. They are not
required if there is an available port.
•
Firmware is subject to change without
notice.
NOTE
If your versions of E-tube Project software and
firmware for each component are not up to
date there could be problems operating the
bicycle. Check the versions and update to the
latest ones.