ADJUSTMENT
Adjustment of the rear derailleur
ADJUSTMENT
Adjustment of the rear derailleur
1
Install the battery.
(A)
(B)
2
(C)
< Checking the distance between the largest sprocket and the guide pulley >
To be continued on next page
Adjust the end adjustment screw (D).
Mount the chain on the smallest
(D)
chainring and the largest sprocket (A),
and turn the crank arm.
Adjust the end adjustment screw (C) so
that the guide pulley does not interfere
with the sprocket, but do not let the
guide pulley come so close to the chain
that they come into contact with each
other.
Set the rear derailleur on the largest
sprocket (E), and with the wheel
stopped, make sure that the clearance
(E)
between the tip of the guide pulley (F)
and the tip of the largest sprocket is
(a)
within the range of 5 to 6 mm.
(a) 5 - 6 mm
(F)
51
(A)
Largest sprocket
(B)
Smallest sprocket
(C)
Guide pulley
(D)
End adjustment screw
(E)
Largest sprocket
(F)
Guide pulley
NOTE
Check the distance between the largest
sprocket and the guide pulley with the rear
suspension at its greatest extension.