Installation Of The Shifting Switch - Shimano XTR Di2 Dealer's Manual

INSTALLATION

Installation of the shifting switch

„ Installation of the shifting switch
The illustration shows the right-side lever.
(A)
1
2
3
X Y
(B)
(C)
(D)
Pass the handlebar (A) through the
shifting switch (B).
Adjust the attachment position and
angle, and then use an Allen key to
tighten the unit fixing bolt (C).
Adjust the positions of lever X and lever
Y.
Loosen the lever fixing bolt (D) using an
Allen key, and adjust the lever's position
so that it is easy to push.
After determining the position, tighten
to the designated torque.
21
(A)
Handlebar
(B)
Shifting switch
Applicable handlebars: ϕ22.2 - ϕ22.5
(C)
Unit fixing bolt
Tightening torque
0.9 N·m
{7.9 in. lbs.}
NOTE
Attach the lever in a position where it will not
touch the brake lever when pushed all the
way in.
(D)
Lever fixing bolt
Tightening torque
0.5 - 0.7 N·m
{4.4 - 6.1 in. lbs.}