Installing The System Information Display - Shimano XTR Di2 Dealer's Manual

INSTALLATION

Installing the system information display

„ Installing the system information display
Install the system information display or junction (A) first.
Replacing the clamp band
(A)
Installing to the handlebar
1
2
(B)
(B)
(A)
(C)
If using a handlebar with a thick
diameter, reinstall it using the included
ϕ 35 clamp band.
Remove the case fixing bolt (A) with an
Allen key and replace the clamp band
(B).
Insert the clamp band (B) of the system
information display (A) into the
handlebar.
Adjust the angle of the system
information display so that it is easy to
see, and then use an Allen key to tighten
the clamp bolt (C).
19
(A)
Case fixing bolt
(B)
Clamp band
Tightening torque
0.6 N·m
{5.3 in. lbs.}
(A)
System information display
(B)
Clamp band
(C)
Clamp bolt
Tightening torque
0.8 N·m
{7.0 in. lbs.}
NOTE
Recommended installation angle of the
information display:
The angle of the display is between 15° to 35°
to the horizontal.
35°
15°