Vision Fitness S7100 Suspension elliptical Service Manual page 49

7.16 peDal aRM ReplaceMent - continueD
4) remove the link arm as outlined in section 7.15.
5) remove the screw holding the pedal arm to the swing arm (Figure E).
6) remove the pedal arm from the swing arm making sure that the washers stay in position on the swing arm (Figure F).
fiGuRe e
7) remove the plastic cover and then the screw holding the crank to the pedal arm and remove the crank (Figures G & h).
fiGuRe G
8) reverse steps 1-7 to install a new pedal arm. NOTE: when re-installing the 14mm nut removed in step 2, be sure to tighten the nut to 70
n-m of torque.
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe f
fiGuRe H
45