Drive Belt Replacement - Vision Fitness S7100 Suspension elliptical Service Manual

7.10 DRiVe belt ReplaceMent

1) remove the front shrouds as outlined in section 7.1.
2) Disconnect the ECB wire harness at the lower control board (Figure a).
3) remove the 2 eye bolts putting tension on the ECB (Figures B & C).
4) remove the 3 screws holding the drive axle assembly to the frame on both sides (Figure D).
fiGuRe a
fiGuRe c
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe b
fiGuRe b
33