Troubleshooting - General Notes - Vision Fitness S7100 Suspension elliptical Service Manual

6.2 tRoubleSHootinG - GeneRal noteS

1) you must be moving (rotating the crank) to elevate the ramp.
2) to get to the ECB, you will need to take the left side crank and side cover off.
3) to get to the lower Control Board, you will need to take the right side crank and side cover off.
4) Use a 22 mm crank puller to remove the bike cranks.
5) this product has 2 power switches. If there are power issues, first check to make sure both switches are in the on position.
CaUtIon: when servicing this machine, be careful not to touch live power cables or connectors. this product uses 110 power, not the typical
12 volt power.
General torque specifications to use when no specification has been set for socket head cap
screws.
Use this one for general cases
and for button head screws.
Grade 8.8
M4 3 n-m
M5 6 n-m
M6 10 n-m
M8 23 n-m
M10 46 n-m
M12 80 n-m
cHapteR 6: tRoubleSHootinG
GENERAL NOTES
Use this one only if you can prove the
fastener will be grade 10.9 or higher.
Grade 10.9
4 n-m
8 n-m
13 n-m
33 n-m
65 n-m
113 n-m
Use this one only if you can prove the fastener will be
grade 12.9.
Grade 12.9 nominal use Grade 12.9 critical use
5 n-m
10 n-m
16 n-m
39 n-m
77 n-m
135 n-m
6 n-m
12 n-m
20 n-m
50 n-m
94 n-m
160 n-m
17