7.3 cup HolDeR aSSeMbly ReplaceMent
1) remove the console as outlined in section 7.2.
2) remove the 5 screws holding the cup holder assembly to the console mast (Figures a & B).
fiGuRe a
3) remove the cup holder assembly from the console mast being careful not to damage the console cable / hr wiring (Figures C & D).
fiGuRe c
4) reverse steps 1-3 to install a new cup holder assembly.
5) test the suspension elliptical for function as outlined in section 7.21.
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe b
fiGuRe D
25