Console Mast Replacement - Vision Fitness S7100 Suspension elliptical Service Manual

7.6 conSole MaSt ReplaceMent

1) TIP: Press start, then incline the unit to its top position. hold the start key to reset the console, and then press any key to stop the
incline from resetting. It will be much easier to remove the console mast with the incline in the top position.
2) remove the right side front shroud as outlined in section 7.1.
3) remove the console as outlined in section 7.2.
4) remove the cup holder assembly as outlined in section 7.3.
5) remove the console mast covers as outlined in section 7.4.
6) Cut the tie straps holding the console cable to the console mast, and remove the upper console cable from the console mast.
7) remove the 2 screws holding the plastic cover that is mounted over the arm juncture (Figure a) and remove the cover.
8) remove the 4 screws / nuts holding the arm juncture together. this will allow you to move the arms out of the way of the incline motor
bracket (Figures B & C).
9) remove the screw / nut holding the incline motor bracket to the incline motor (Figure D).
fiGuRe a
fiGuRe c
28
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe b
fiGuRe D