Console Cable Replacement - Vision Fitness S7100 Suspension elliptical Service Manual

7.5 conSole cable ReplaceMent

1) remove the right side front shroud as outlined in section 7.1.
2) remove the console as outlined in section 7.2.
3) remove the cup holder assembly as outlined in section 7.3.
4) remove the console mast covers as outlined in section 7.4.
5) remove the tie straps holding the console cable to the console mast (Figure a).
6) Disconnect the upper console cable from the lower console cables (Figure B).
fiGuRe a
7) Disconnect the lower console cables at the lower control board and ECB (Figures C & D).
fiGuRe c
8) reverse steps 1-7 to install a new console cable.
9) test the suspension elliptical for function as outlined in section 7.21.
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe b
fiGuRe D
27