Vision Fitness S7100 Suspension elliptical Service Manual page 40

7.11 DRiVe axle Set ReplaceMent - continueD
5) once the ECB and drive axle assembly are loose, the drive belt can be removed from around the drive axle assembly allowing the ECB to drop
down outside of its bracket (Figures E & F).
fiGuRe e
6) once the ECB is dropped down outside of its bracket, the drive can be removed from around the ECB pulley (Figure G).
7) on the left side of the unit, move the mounting bearing from the drive axle assembly towards the middle of the frame. this will allow you to
move the belt around the drive axle assembly and off the unit (Figure h).
fiGuRe G
8) Disconnect the incline motor at the bottom connection.
9) once the incline motor is disconnected at the bottom connection, it can be swiveled and the drive axle assembly can be removed from the frame.
10) reverse steps 1-9 to install a new drive axle set.
11) test the suspension elliptical for function as outlined in section 7.21.
36
cHapteR 7: paRt ReplaceMent GuiDe
fiGuRe f
fiGuRe H