Transfer Belt Cleaning Bias; Transfer Belt Auto Cleaning; Aidc Table Correction - Konica Minolta bizhub C350 Service Manual

TECH. REP. MODE
4.16.2

Transfer Belt Cleaning Bias

Functions • To set the strength of the Transfer Belt cleaning bias
Use • To change the Transfer Belt cleaning bias to the standard value when a Transfer Belt
Setting/ • The default setting is "High."
Procedure
4.16.3

Transfer Belt Auto Cleaning

Functions • To carry out a 1-min. cleaning sequence for every 1,000 printed pages (FD: 216 mm
Use • To select "Disable" for Transfer Belt Auto Cleaning if the wait time of 1-min. cleaning
Setting/ • The default setting is "Enable."
Procedure
4.16.4

AIDC Table Correction

Functions • To set the upper limit value of Vb during the execution of the image stabilization
Use • To select "Disable" for AIDC Table Correction if a higher density image is desired
Setting/ • The default setting is "Enable."
Procedure
• Enable: Sets the upper limit value for Vb
• Disable: Does not set the upper limit value for Vb
3-98
1
cleaning failure occurs due to overcurrent under high humidity conditions
High Std.
or less) after the power has been turned ON
sequence is to be eliminated
Enable Disable
sequence, thereby preventing part of the Photo Conductor surface from being left
uncleaned due to filming
Enable Disable
bizhub C350 Field Service Ver2.0 Sep. 2004