Konica Minolta bizhub C350 Service Manual page 111

Other
[29]
[32]
[31]
[33]
[36]
[35]
A
B
C
[37]
21. Remove the Cable Holding Jigs from the front and rear pulleys.
22. Adjust the focus positioning of the Scanner and Mirrors Unit.
☞ 3-104
23. Adjust the position of the Scanner and 2nd/3rd Mirrors Carriage.
☞ 3-104
NOTE
• Whenever the Scanner Drive Cables have been removed, be sure to carry out the
"FD-Mag" adjustment procedure.
☞ 3-46
2-72
bizhub C350 Field Service Ver2.0 Sep. 2004
[30]
4036fs2568c0
[34]
4036fs2569c0
[38]
4036fs2570c0
<Rear>
17. Wind the bead end of the cable [29]
around pulley F [30] and pulley E
[31], then hook the bead [32] onto
the Adjustable Anchor [33].
18. Wind the hook end of the cable [34]
around pulley D [35] and pulley E
[36].
19. Fit the hook end of the cable [37] to
the spring [38] and then hook the
spring to the catch A in the frame.
20. Measure the Spring length, and
check if its length is within the range
of 63.0 mm ± 1 mm.
<When out of the given range>
• In case of 64.1 mm or more:
Retry to put the spring on the catch B.
• In case of 61.9 mm or less:
Retry to put the spring on the catch C.