Protocol Setup Options - Canon ColorPass-Z7400 Configuration Manual

4
4-19 Network Setup options
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Network Setup
Protocol Setup
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup

Protocol Setup options

To configure the ColorPASS, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select Yes if you have an AppleTalk network connected to the ColorPASS. This
setting enables the ColorPASS to communicate over AppleTalk networks.
AppleTalk Zone
List of zones
The ColorPASS searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the ColorPASS
to appear. If your segment has only one zone, the ColorPASS is assigned to that
zone automatically.
The message "No AppleTalk zone found" may mean your network has no zones, or the
network cable is not connected (see
TCP/IP Setup options
To configure the ColorPASS for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet) and enter the appropriate settings.
When you set an IP address, subnet mask, or gateway address for the ColorPASS
during Setup, you can allow the ColorPASS to get these addresses automatically from a
DHCP or BOOTP server. Turn on or restart the ColorPASS and allow it to reach
Idle. Make sure the DHCP or BOOTP server is running, and then perform
ColorPASS Setup.
Appendix A). Choose OK to dismiss the message.