Canon ColorPass-Z7400 Configuration Manual page 81

4
4-17 Network Setup options
For this Network or
Connection Type
AppleTalk over Ethernet
TCP/IP over Ethernet
IPX/SPX over Ethernet
T N
O ACCESS
1. Confirm that the network cable is connected to the ColorPASS.
2. Choose Network Setup from the main Setup menu.
3. Choose Port Setup from the Network Setup menu.
4. Choose Ethernet Setup from the Port Setup menu, and enter the appropriate settings.
5. When you have finished entering port settings, choose Exit Port Setup, and then
6. Enter the appropriate settings for the protocol(s) you will use.
If the ColorPASS is configured to enable more than one protocol, it automatically
switches to the correct protocol when it receives a print job.
The available network types, and the Setup areas that pertain to them, are summarized
in the following table.
Use this
Port Setup
Ethernet Setup AppleTalk Setup
Ethernet Setup TCP/IP Setup: Ethernet Setup
Ethernet Setup IPX/SPX Setup
S
ETWORK ETUP OPTIONS
During Network Setup, the ColorPASS queries the network for zones, servers, and
server-based queues. If you perform Network Setup without a connected and
functioning network, default settings are used that may not meet your needs.
choose Protocol Setup.
Use this
Protocol Setup
AppleTalk printing (PAP) is
enabled automatically.
LPD Setup
Web Services Setup
Windows Setup
Port 9100 Setup
(Windows 2000/XP/Server
2003)
IPP Setup
(Windows 98/Me/2000/XP/
Server 2003)
PServer Setup (NDS, Bindery,
or both)
Use this
Service Setup