Canon ColorPass-Z7400 Configuration Manual page 197

A
A-9 Troubleshooting
Cannot connect to ColorPASS with Fiery utilities
If users cannot connect to the ColorPASS, check the following:
• ColorPASS Setup—the appropriate network protocol must be enabled, with the
correct parameters (for example, for TCP/IP, the IP address), and you must publish
either the Print queue or Hold queue.
You can check these settings quickly by printing a Configuration page.
• On the client workstation—the appropriate network protocol(s) must be loaded,
and your Windows directory should contain a configured Efinl.ini file.
Cannot connect to the ColorPASS with Command WorkStation
If there is a problem connecting to the ColorPASS, an error message is displayed.
The problem can occur when:
• The ColorPASS is initially turned on.
• The ColorPASS restarts.
• You have changed settings affecting the server address and have not reconfigured the
connection to the server.
If you see this problem, try the following solutions, in this order:
• A remote workstation running Fiery utilities or Fiery WebTools may be interfering
by obtaining status information. If possible, close the remote application, and try to
connect again.
• Restart the Command WorkStation software and try to connect again.
• Check the configuration of the connection and modify it, if necessary, or delete the
Efinl.ini file and start over with the process of configuring the connection as
described in the
For Windows 98/Me, the Efinl.ini file is located in \WINDOWS.
For Windows NT 4.0/2000/XP/Server 2003, the Efinl.ini file is located in
\WINNT.
• Restart the ColorPASS.
For information on other error conditions, see the
User Software Installation Guide.
Job Management Guide.