Table of Contents
Advertisement
3
3-2 Preparing for ColorPASS Setup
In addition, you can enable the Printed queue, which is a storage area for the most
recent jobs from the Print queue. The Printed queue makes it convenient to reprint
those jobs. In Setup, you can enable the Printed queue and specify the maximum
number of jobs retained in the queue (see
page 4-16). Reprinting jobs in the Printed queue requires the job management tools.
To use the Fiery utilities and Fiery WebTools, you must enable at least one of the
print connections.
Hold queue
Jobs sent to the Hold queue are spooled to the ColorPASS hard disk drive for printing
at a later time or for reprinting. Because the Hold queue is a storage place, jobs sent to
it cannot proceed through the printing process until the operator intervenes using the
job management tools (see the
Print queue
This is the standard ColorPASS queue. Jobs sent to the Print queue are processed and
printed in the order they are received. Jobs prioritized by an operator with the job
management tools and jobs sent via the Direct connection take priority over jobs sent
to the Print queue.
Direct connection
The Direct connection transmits jobs directly to the ColorPASS, but only when the
ColorPASS is Idle. If the ColorPASS is busy, the job remains at the user workstation
until the ColorPASS is ready. The job is then processed as soon as the previous job is
finished and before the next queued job is processed.
Jobs sent to the Direct connection are not stored on the ColorPASS hard disk drive,
and cannot be selected for reprinting, moving, or deletion. Jobs sent to the Direct
connection do appear in the Job Log, for accounting purposes.
To download fonts to the ColorPASS, you must publish the Direct connection.
N
:
OTE
The Direct connection is not supported for LPR printing.
N
:
OTE
"Jobs Saved in Printed Queue 1-99 [10]"
Job Management
Guide).
on
Advertisement
Table of Contents
