Table of Contents
Advertisement
5
5-32 Setting up the ColorPASS from a Windows Computer
Enable SMB Print Services/Enable Windows Printing Service
(Server Message Block), the file and printer sharing protocol built into Windows.
Enabling SMB lists the ColorPASS on the network so that Windows clients can print
to a particular print connection (Hold, Print, or Direct) on the ColorPASS without
any other networking software. For information on setting up a Windows client for
Windows printing, see the
Windows (SMB) printing runs over TCP/IP, so you must configure TCP/IP on
N
:
OTE
the ColorPASS and any computers that use Windows printing.
The remaining options are found only in remote Setup. To change them with local
Setup, use the Local Area Connection Properties Control Panel in Windows XP
Embedded.
—Enter the server name that will appear on the network. It can, but does
Server Name
not have to, be the same name as the server name assigned to the ColorPASS
(see
"Server Name"
—Enter information about the printer, up to 15 characters. These comments
Comment
are listed in the Properties of the ColorPASS in Network Neighborhood. Lowercase
letters are allowed in this field.
Domain or Workgroup
should appear.
Ethernet WINS Server
Broadcasts from SMB devices cannot be routed beyond their original network segment
without a WINS name server. Setting up the WINS name server is outside the scope of
this manual. To find out if a name server is available, contact your network
administrator.
User Software Installation
on page 5-4).
—Enter the workgroup or domain where the ColorPASS
—Enter the IP address of the Ethernet WINS name server.
—Select to enable SMB
Guide.
Advertisement
Table of Contents
