Tyre Pressure Monitoring - Skoda Yeti Owner's Manual

If none of these conditions are met or if the driving style is not changed, the
system recommends a driving break again after 15 minutes.
Activation/deactivation
The system can be activated/deactivated via the MAXI DOT display in the As-
sistants menu option » page 47.
Information messages

Read and observe on page 157 first.
In MAXI DOT display the icon appears for a few seconds  and the following
message.
Fatigue detected. Take a break!

An audible signal is also emitted.

Tyre pressure monitoring


Introduction
This chapter contains information on the following subjects:
Save tyre pressure values
The tyre pressure monitoring function (hereinafter referred to only as a sys-
tem) monitors the tyre pressure while driving.
If the rolling circumference of a wheel is changed, the warning light
instrument cluster lights up and an audible signal sounds.
Information on the procedure for the notification of change of tyre inflation
pressure » page 40.
The system can only function properly if the tyres have the prescribed inflation
pressure and these pressure values are stored in the system.
WARNING
Having the correct tyre inflation pressure is always the driver's responsi-
■
bility. Tyre pressure should be checked regularly
The system cannot warn in case of very rapid tyre inflation pressure loss,
■
e.g. in case of sudden tyre damage.
158
Driving
158
in the

» page 191.
Save tyre pressure values

Read and observe on page 158 first.
Save the tyre pressure values as follows.
›
Inflate all the tyres to the specified pressure.
›
Switch on the ignition.
›
Press  » Fig. 146 symbol icon and hold down.
The warning light in the instrument cluster lights up.

An acoustic signal and the control indicator provide information about the
storage of the tyre pressure values.
›
Press  icon button.
Always save the tyre pressure values in the system if one of the following
events occurs.
›
Change of tyre inflation pressure.
›
Change one or more wheels.
›
Change in position of a wheel on the vehicle.
›
Illumination of the warning light
WARNING
Before storing the pressures, the tyres must be inflated to the specified in-
flation pressure » page 191. If the wrong pressure valuesare stored, the
system may not issue any warnings, even if the tyre pressure is too low.
CAUTION
Save the tyre pressure values every 10,000 km or 1x annually to ensure correct
system functioning.
Fig. 146
Key for storing the pressure val-
ues
in the instrument cluster.